Sump Waterproofing in Chennai

Quick answer:

Sump waterproofing seals the inside of an underground sump so stored water stays in and ground water stays out. Wall-floor joints, pipe entries and cracks are repaired or injected first. The surfaces then receive a crystalline or cementitious coating that is safe for drinking water. In Chennai’s low-lying areas, it also keeps monsoon ground water from contaminating the supply.

Book Your Expert Site Visit

Share your requirement and our waterproofing specialists will inspect the site and send you a tailored quotation.

Your information is safe and will not be shared.

Established 2016

A highly experienced applicator delivering superior quality compared to major brands.

Genuine Warranty

Warranty for Product + Service
promise to repair or replace a defective product or service at no extra cost.

Brands we used

SikaFosroc
Dr. FixitMYK Arment
PenetronArdex Endura
MAPEIMC-Bauchemie
CICOCCI
Dr. FixitMYK Arment
Local conditions

Why underground sump waterproofing matters in Chennai

Almost every home and apartment block in Chennai depends on an underground sump. Metro supply arrives for limited hours, and tanker water has to be stored somewhere, so the sump is the household’s main reserve. When it leaks, you pay for water that drains into the soil.

The larger risk runs the other way. Sumps sit below ground, often a few feet from a septic tank, a sewer line or a storm drain. In the monsoon the water table rises, in some areas to within a few feet of the surface. Ground water then presses on the sump walls from outside. If the walls or joints are porous, contaminated water seeps into your drinking supply. Families notice it as a smell, a change in colour or repeated stomach illness after the rains.

Street flooding adds one more route: dirty water entering through a badly sealed manhole cover.

Signs your sump needs attention

  1. Water level dropping overnight when nothing is in use
  2. More tanker loads needed than before
  3. Muddy, yellowish or foul-smelling water, especially after rain
  4. Water level rising by itself during the monsoon
  5. Damp, soft or sinking ground around the sump
  6. Visible cracks, flaking plaster or roots inside
  7. Salty taste in areas with brackish ground water
  8. A manhole frame that is cracked or sits below ground level
Root cause

What is actually going wrong

The wall-floor joint has opened.

 As in any tank, this joint carries the most pressure and is the usual leak point.

The walls are porous.

 Many older sumps are built in brickwork with cement plaster. Brick absorbs water readily, and once the plaster cracks there is little resistance in either direction.

Pressure comes from both sides.

 When the sump is full, water pushes out. When it is low and the water table is high, water pushes in. A coating that only resists pressure from the inside can be pushed off the wall from behind.

Pipe entries are unsealed.

Inlet lines, suction pipes and overflow openings pass through the walls with only mortar packing around them.

Roots and settlement.

Tree roots seek out moisture and widen small cracks. Vehicle movement above a sump under a driveway does the same.

The cover slab and manhole leak.

Surface water runs in through gaps around the frame.

Recommended systems

SystemWhere we use itNotes
Crystalline waterproofing coatingWalls and floorGrows crystals into the concrete pores and resists pressure from both sides
PU injection groutingActively leaking joints and cracksStops inflow before coating
Cementitious pressure groutingPorous walls and honeycombed sectionsFills voids from within
Potable-grade polymer cementitious or food-grade epoxy coatingFinal interior liningCertified safe for drinking water
Non-shrink grout and sealantPipe entriesPacked and sealed
Raised, sealed manhole frameCover slabKeeps surface water out

Crystalline treatment is the core of most sump jobs because it becomes part of the concrete and cannot peel off under back pressure.

Our process

How we do the work

  1. Inspect and test.We check water loss over 24 hours, examine the inside and note nearby septic tanks and drains.
  2. Empty and clean. Water is pumped out and sludge removed.
  3. Ventilate.A sump is a confined space. We run a blower and check the air before anyone enters, and a second person stays at the opening throughout.
  4. Stop active leaks.Any ground water coming in is sealed by injection.
  5. Repair.Loose plaster is removed, cracks opened and filled, and roots cut back and sealed.
  6. Detail the joints.A coving is formed at the wall-floor joint and pipe entries are repacked.
  7. Coat.Two coats of crystalline or potable-grade coating on the walls, floor and underside of the cover slab.
  8. Cure. The surface is kept damp for the period the product requires, usually five to seven days.
  9. Seal the manhole.The frame is raised if needed and sealed.
  10. Disinfect and refill.The sump is washed, chlorinated, filled and monitored for 48 hours.
Plan for about a week without the sump. We can help arrange a temporary tank for the period.

Frequently asked questions

1

How do I know my sump is leaking?

Fill it, switch off the motor, close the inlet and mark the level. Check again after 24 hours with no water drawn. Any drop is a leak.

2

Can ground water really get into a concrete sump?

Yes. Under monsoon pressure, water passes through porous concrete, brickwork and joints. This is a common cause of contaminated sump water in the city.

3

Is sump waterproofing different from overhead tank waterproofing?

The coatings are similar, but a sump is pushed on from both sides. Stored water presses outward and ground water presses inward. The system has to resist both, which is why crystalline treatment and joint injection are used more often in sumps.

4

Is the coating safe for drinking water?

Yes. We use only potable-grade materials and disinfect the sump before refilling.

5

My sump is next to the septic tank. Is that a problem?

It is a risk. Waterproofing both the sump interior and the joints is strongly advised, and we check the septic tank side during inspection.

6

Can the work be done during the monsoon?

Yes, though active inflow must be injected first. Dry months make the job quicker.

7

How long will we be without water during sump work?

The sump is usually out of use for about a week, most of it curing time. We help you plan a temporary tank or tanker supply before work starts.

8

Is there a warranty?

Yes, a written warranty is given after the fill test.

Protect your water - Call or WhatsApp WATREX for a sump inspection anywhere in Chennai and a written quote.